A15 Elastic Bungee Uses: Tie Down Hides and Camo Netting

By Wildlife Watching Supplies - Kevin Keatley - Wildlife Watching Supplies | Published: 2026-11-01

Category: How-to Guides

Learn how to use the A15 Elastic Bungee to secure camouflage netting and gear in hide setups, with a step-by-step process and practical checkpoints.

Quick answer

Use the A15 Elastic Bungee to tension camouflage netting and lash light gear to hide frames. Cut it to the length you need and tie it off with a simple loop or knot, checking tension before you leave it in place.

Why elastic bungee suits hide setups

Elastic cord keeps steady tension on netting and fabric even when wind or movement shifts the load. That makes it more forgiving than fixed cord for securing camouflage netting over uneven frames or between poles. The A15’s 6mm diameter gives a useful balance of stretch and strength for outdoor photography setups, while the olive color blends into natural surroundings.

Length and tension: where setups go wrong

The most common mistake is cutting the cord too short and over-stretching it, which can distort netting or put strain on attachment points. Cut a little longer than the span you need, then tension gradually. Because the A15 is sold by the meter in continuous lengths from 1 to 10 meters, you can order the exact length for your hide rather than joining offcuts. Remember that elastic cord is not a load-rated tie-down for heavy equipment; use it for netting, tarps, and light gear only.

Step-by-step: using the A15 Elastic Bungee in a hide

Measure the span: Run a tape or cord along the path the bungee will take—around a pole, across a netting edge, or between two anchor points—and note the length. Add about 20–30% extra for stretch and tying off. Check that your measured length falls within the 1–10 meter continuous length you order.
Cut and seal the end: Cut the bungee cleanly with sharp scissors. If the cord is exposed to repeated handling, melt the cut end briefly with a lighter to reduce fraying, taking care not to inhale fumes or burn the cord. Do not over-melt; a rounded tip is enough.
Anchor one end first: Tie the bungee to a fixed point such as a hide pole or stake using a secure loop or knot, leaving the other end free. Pull gently to test the knot before adding tension. If the knot slips, add an extra half hitch before continuing.
Thread through the netting: Pass the free end through grommets, around the netting edge, or over the fabric at the points where you need tension. Keep the cord flat against the material to avoid twisting. Twisted cord concentrates stress and can tear netting; smooth it out as you go.
Tension and tie off: Stretch the bungee only enough to remove slack and hold the netting steady—roughly 10–20% beyond its resting length. Tie off to the second anchor point and check that the netting hangs naturally without distortion. Over-stretching weakens the cord and can pull stakes loose; if the netting puckers, release tension.
Test and adjust: Gently push on the netting and frame to simulate wind. Retie any connection that shifts or loosens, and trim excess tail leaving a short end for future adjustment. Recheck tension after the first hour of use, as elastic cord can settle.

Product facts

A15 Elastic Bungee: 6mm diameter elastic bungee cord in olive, sold by the meter in continuous lengths from 1 to 10 meters. You can order exactly the length needed for your hide frame or netting span, with no unnecessary joins.
A15 Elastic Bungee